Made in the USA
Define The Cage Boundary And Project Scope
Mark the proposed enclosure on the facility plan with dimensions, partition height, adjacent tenants or equipment, and the areas that must remain accessible. Identify whether the project is a new fit-out, an expansion, or work within an operating data center. These conditions affect how the cage can be delivered and installed.
Show the equipment footprint and the service clearances required by the facility and equipment suppliers. A boundary that fits on a floor plan can still interfere with a cabinet door, equipment replacement route, or maintenance task. Use the plan to resolve those conflicts before the panel layout is finalized.
Select The Partition Construction
NWW supplies data center and colocation cages using project-appropriate partition construction. ProGuard uses angle-framed panels; MaxGuard uses channel-framed construction. Compare the systems with the project’s mesh, framing, height, door, and support requirements.
Provide the written security or construction specification when one exists. Do not select a system by product name alone or assume a particular mesh satisfies every facility policy. For an expansion, document the existing cage and the proposed connection so the new work can be reviewed against the installed conditions.
Document Floors, Supports, And Restricted Drilling
Identify concrete floors, raised access floors, floor finishes, and changes in elevation along the cage. Show where posts and supports are proposed and identify any floor areas where drilling or fastening is restricted. If the partition interfaces with a raised floor, provide the relevant floor construction and support requirements.
Clarify who is responsible for floor modifications, anchors, and work below the floor. Underfloor services and concealed conditions need to be coordinated with the facility team. A finished floor photograph is helpful, but it cannot establish the structure or services beneath it.
Coordinate Cable Routes And Overhead Conditions
Show cable trays, ducts, pipes, lighting, sprinklers, and other services that cross or run close to the cage. Mark the location and dimensions of required openings. Include the relationship between the cage height, any top closure, and the building services above it.
Coordinate airflow and equipment cooling requirements with the project’s mechanical design. Mesh permits visibility and air movement, but the complete layout and selected infill still need review against the facility’s requirements. If a mesh ceiling is requested, define its extent and service access; it is not a walking platform.
Plan Clear Access And Hardware Interfaces
Size doors for the largest equipment that must move through the opening and show the clear passage required. Check door operation against cabinet rows, aisles, adjacent cages, and equipment handling routes. Identify any planned future equipment movement that should be accommodated now.
Describe the locking or access-control requirement and identify the hardware or security contractor’s scope. Provide details for any specified device, wiring interface, or mounting provision rather than assuming it is included in a standard door. Exit-route and emergency-access requirements should be resolved with the project team and facility before ordering.
Include Installation Conditions In The Quote Request
Send the dimensioned plan, height, system requirements, mesh and finish, doors and hardware, top closure, service openings, floor information, and specification. Include delivery access, loading restrictions, work hours, installation phases, and any constraints associated with an operating facility. State the required schedule and which work is by others.
Use the project quote form to attach the package. The ProGuard design studio can help communicate a concept layout when that system is being considered. Find product literature in the document library and review the partition system comparison before completing the specification.